Whole-system duct and dryer vent check with before-and-after photos - you see exactly what came out of your vents
That "$99 whole-house special" is a bait ad - the real number appears once they are in your hallway, or the "clean" is a shop-vac at the register. We photograph the inside of your ducts before and after instead.
Before
After
Before
After
Before
AfterRotobrush Air Quality & Sanitizing in Cumming: What to Know First
We provide independent Rotobrush air quality and sanitizing service in Cumming, typically completing mold treatment, bacteria sanitizing, and odor removal jobs within a single scheduled visit. Written pricing is delivered before any work starts under Haven Standard Clause 1, with whole-system air quality service ranging from $340 to $780 depending on system size and contamination level. Every job includes a Documented Photo Record of each duct run, before and after, so you can verify what was actually done rather than taking a verbal report. This page is for Rotobrush owners in Cumming who need sanitizing work done correctly and documented, not sold through a coupon pitch. Call (678) 693-5322 for a written estimate at no cost.
How Rotobrush Products Fail - and How We Fix Them
- Rotobrush BrushBeast and aiR+ series: The flexible cable drive in these units can harbor moisture in Cumming’s humid spring and summer months, creating a breeding ground for mold inside the machine itself that then gets distributed through your ductwork during routine cleaning. We disassemble the cable housing, treat with EPA-registered sanitizer, and verify with ATP testing before the machine touches your system again.
- Rotobrush DuctMaster negative-pressure units: The HEPA filtration seal on older DuctMaster models degrades after roughly 400 service hours, allowing captured bacteria and mold spores to bypass filtration and re-enter the home during operation. We replace the seal with OEM-spec gaskets and run a particle-count verification test before declaring the job complete.
- Rotobrush aiR+ XP with UV accessory: The factory UV-C lamp in the aiR+ XP sanitizing attachment loses effective output after 9,000 hours, well before the lamp fails entirely, leaving homeowners with what looks like active sanitizing but diminished germicidal effect. We meter actual UV output with a radiometer and replace lamps at measured degradation, not just at burnout.
- Rotobrush portable fogging systems: The diaphragm pump in portable fogging units used for whole-house bacteria treatment can develop micro-cracks that dilute sanitizer concentration by drawing in ambient air, particularly problematic in Cumming where pollen and outdoor mold spore counts run high March through October. We pressure-test the pump assembly and replace the diaphragm with quality aftermarket parts rated for sanitizer chemical exposure.
- Rotobrush duct inspection cameras: The camera head on the standard Rotobrush inspection system accumulates biofilm in humid duct environments, transferring contamination from one duct run to the next and giving false readings on “clean” sections. We sterilize the camera head between every run with hospital-grade disinfectant, a step most crews skip, and we document the sterilization in your job record.
Our Rotobrush Air Quality & Sanitizing Process
- 1
Written scope and price delivered first. We inspect your Rotobrush system and ductwork with our own camera, identify contamination type and extent, and give you a written price before any panel comes off. Haven Standard Clause 1: no exceptions.
- 2
Equipment decontamination. Any Rotobrush machine we bring into your home is disassembled, sanitized, and verified clean before arrival. The camera doesn’t have an opinion - it just shows you what’s in there.
- 3
Targeted sanitizing treatment. We apply EPA-registered sanitizer matched to your specific contamination: quaternary ammonium compounds for bacterial loads, botanical antimicrobials for mold-sensitive households, or peroxide-based treatments for heavy organic buildup. OEM-spec application rates, never diluted.
- 4
UV or air purifier installation if indicated. For recurring contamination, we install Honeywell or Aprilaire UV-C systems or standalone air purifiers with documented CFM ratings, wired to your Rotobrush-compatible HVAC configuration.
- 5
Post-treatment verification and photo record. We photograph every treated duct run, deliver the before-and-after record to you, and run a final air sample if mold was present. The 365-Day Done Right Promise attaches in writing.
- 6
Cleanup and documentation. All access panels sealed, registers restored, and a complete job record with photos, product labels, and warranty terms left with you before we leave.
BeforeAfterWhat Rotobrush Air Quality & Sanitizing Costs in Cumming
Whole-system bacteria or mold sanitizing for a Rotobrush-serviced home in Cumming typically runs $340 to $540 for systems up to 2,500 square feet, and $480 to $780 for larger homes with multiple zones or heavy contamination. UV light installation adds $280 to $520 per unit depending on lamp wattage and duct access difficulty. Standalone air purifier installation ranges from $340 to $680 based on unit capacity and electrical requirements.
What moves the price: square footage and duct run count, contamination severity visible in the initial camera inspection, whether the evaporator coil also needs treatment (common in Cumming’s two-story Vickery homes where return-air trunk lines hold debris), and whether we’re retrofitting UV into a Rotobrush system not originally equipped for it. We do not quote per-vent pricing. One flat price per system, agreed in writing, before work starts. Call (678) 693-5322 for an exact quote - estimates are free.
Why Cumming Homeowners Call CleanRun Air Duct Cleaning Cumming for Rotobrush Work
We’ve been documenting duct conditions with cameras since 2013, long before it became a marketing bullet point. The 365-Day Done Right Promise is backed in writing on every job, not buried in a policy manual. Our technicians are background-checked and uniformed under Haven Standard Clause 3: Verified Crews, and they know Rotobrush equipment well enough to spot when a “sanitizing” job was performed with an unclean machine. We also service Lennox, Trane, and Carrier systems, so we’re not guessing when your Rotobrush unit interfaces with a major-brand HVAC backbone. Tomas Reyes and our crew have run jobs across Cumming for years, including the two-story layouts in Vickery where return-air trunk lines hide surprising debris loads. Every call is answered by a live person, and every estimate includes a Free Second Opinion on any competitor’s written quote.
FAQs
No, properly applied EPA-registered sanitizers and OEM-spec replacement parts do not void your Rotobrush warranty, though using non-compatible chemicals or unauthorized parts can. We document every product and part number in your job record so warranty coverage remains traceable. Call (678) 693-5322 if you need a copy for warranty filing.
We photograph the inside of every duct run before and after treatment, and we leave you the photo record as a standard deliverable. You can match timestamped images to specific registers in your home. If mold was present, we also offer optional post-treatment air sampling. The 365-Day Done Right Promise covers you if results don’t match documentation.
Repair makes sense when the unit is under eight years old and the failure is isolated to a replaceable component like a UV lamp, pump diaphragm, or seal. Replacement is typically more economical when multiple systems have failed, the unit has been used with unclean equipment that cross-contaminated your ducts, or repair parts are back-ordered beyond practical timelines. We give you both numbers in writing and let you decide.
For UV lamps and HEPA seals, OEM parts maintain warranty compliance and known performance specs. For diaphragm pumps and routine wear items, quality aftermarket parts from Guardsman and Abatement Technologies meet or exceed OEM performance at lower cost and are what we typically install. We label every part source in your job record so you can verify independently.
We typically schedule within three to five business days for non-emergency sanitizing work. Active mold contamination with health symptoms gets prioritized. We do not promise same-day dispatch - proper decontamination of our own equipment and thorough documentation take time that rush scheduling doesn’t allow. Call (678) 693-5322 for the next available slot.
Ready for a written estimate? Call (678) 693-5322. We’ll inspect your Rotobrush system, show you what the camera sees, and deliver a flat price before any work begins. No per-vent games, no coupon bait, just documented results.
Written by Tomas Reyes, Owner, CleanRun Air Duct Cleaning Cumming at CleanRun Air Duct Cleaning Cumming, serving Cumming and nearby areas.